Re: Exhaust header WRT ground clearance.
Re: Exhaust header WRT ground clearance. -- Atzy1	Post Reply	Top of thread	Maverick Message Board

Posted by: Ryan 02/26/2002, 17:11:13

when I still had powersteering on the car I welded the slave cylinder drop bracket a little farther toward the front. I think this put the cylinder in front of were the tubes bend. as long as you don't put too much of an angle on it, it should be alright because there is a ball joint at the other end of the cylinder

Post Reply | Alert

Original message Top of thread Return to the MMB