Re: "Old Timer" Question
Re: "Old Timer" Question -- 3rd_Mav	Post Reply	Top of thread	Maverick Message Board

Posted by: Ken Merring 01/13/2002, 22:58:42

Any of you "old timers" remember if a Holley 3 barrel will fit on most after market high rise manifolds. Recently purchased a 428 SCJ for my 1970 Maverick, and it was equipted w/ a tunnel ram manifold. I am going to convert to a high rise and 3 barrel (1050 CFM). Not too sure if most high rise manifolds are properly notched for the secondaries. Thanx ...................... No, most were not, but it's an easy matter to have the rear divider machined just enough to allow the plate to fully open.

Post Reply | Alert

Original message Top of thread Return to the MMB