What do you use to cut sheet metal?

Discussion in 'Tool & Shop Talk' started by rustymav1974, May 7, 2011.

  1. injectedmav

    injectedmav Member

    Joined:
    Sep 15, 2006
    Messages:
    2,114
    Likes Received:
    26
    Trophy Points:
    142
    Location:
    Georgia
    Vehicle:
    1972 Maverick 2dr 5.0l EFI, 2003 Expedition(wife's), 2002 F150 Supercab King Ranch
    I bought a different brand. The compressor I am using is more than sufficient. I have used some that are airhogs, but this one I borrowed and it didn't even want to spin, so I oiled it and nothing, spins a few rpm's and locks down. The old IR angle one I used professionally for 15+ yrs before the head finally fell off, so I bought an IR to replace the el cheapo.
     
  2. rustymav1974

    rustymav1974 Livin' The Dream

    Joined:
    Feb 10, 2011
    Messages:
    76
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    Midland, Texas
    Vehicle:
    1974 Maverick
    Looked into buying an IR cut-off tool, gonna order one soon. Inectedmav you mentioned spot sand-blasting earlier. I have a sand blaster but what abrasive should I use in it?
     

Share This Page