Did you make this? Also, what gauges will go into which slots? I'm assuming speedo in the middle, but what about the others?
I made it out of 1/4" textured ABS. I'll have to check to see where I ordered it from. The inside corners aren't as clean as they look in the pic. It was my first time using plastic. I made it for the Intellitronic/Summit Racing digital gauges. It will have Speed (3 3/8"), water temp (2 1/16"), oil pressure (2 1/16"), fuel (2 1/16"), volts (2 1/16"), turn signals (.312") and high beam (.312"). The picture isn't that good, but this is the finished product. I spent around $325 shipped for the gauges and senders, The picture isn't that good.
