Separate names with a comma.
I thought I would start this up and add to it as I get the time. I would make it a sticky if I could but I think a moderator would have to do...
Still in PT and not able to do much so for those of you who need the anti-flare kit I have posted it in the sticky post at the top of the...
Since my second operation I am unable to do much so I am providing my anti-flare kit designs and instructions for anyone to use for PERSONAL use...
If you can get a title - and that is sometimes very hard (I have one that I can't get a title to and now I can't even get rid of it) it might be...
If the C4 is unmodified then the band adjustment is torque the adjusting screws to 10 foot pounds and then back off the front 1.5 turns, and the...
Thanks to all of you! I have had lots of time to do some reading so I am putting it to good use.
You need to get your compression up near 13:1 or slightly more to get much power increase.
well, I have had one operation and am going back for a second one. I have a meeting with the neurologist on the 17th of Jan. and with any luck I...
Just use the one you have - just adjust it so it will work with the C4.
OK, you need to get a hole in the linkage that when you advance to WOT it pulls the lever as far as it can without binding the linkage. On the...
You can easily and cheaply make both the line that goes to the air cleaner (filtered air for the choke which comes out the bottom of the manifold...
There is the idle stop screw (which I suspect is correct) and a high idle screw for when the choke is closed - I suspect this is the one that has...
Yep! I am here to help when I can.
If you have a Lokar cable connect it to the kick-down lever on the carb and set it so at WOT the kick-down lever on the transmission is maximized...
since it idles fast when cold and after it warms it idles down it would seem to me that the high idle is set too high. If it takes more than 5-6...
Use what the builder says - if you built it yourself and you used a packaged rebuild kit use type F. Powerglides can use anything from Dexron to...
There should be instructions with the carb on where it connects and how to adjust it. I suggest you read them first.
The AOD uses a throttle pressure rod and it is not compatible with the C4 any more than the C4 kick-down is with the AOD. Get the right linkage.
That would be the T-85 Borg Warner. It used an electric OD solenoid that you could turn on or off and to go into OD you just let up and slam - you...
The transmission oil will desolve Vaseline petroleum jelly so it won't hurt anything after its job is done. Vaseline is good for prelube on all...
