Separate names with a comma.
Hi Max, been along time since I was here too. Got another 72 to put on the street and a 72 drag car. Will post pics later. Right now I need a...
Nice Numbers Great Pic.
WOW, have no doubt you have some awesome numbers to share with us. Like dyno results, HP, Torque and longevity of your builds etc. By the way, how...
Some headers you may have to slide in when dropping the engine in, espedially on the drivers side.
Where to buy a pulse charger?:huh:
At 14 bought a 39 Ford 4dr for 50.00, blew the rear end the next day after racing around the pasture sitting on a cement block to see over the...
I have run the 8in with great success and no problems with 375hp 306 and c4 in drag only car. The biggest problem they have is the small rear...
These are the same di**heads that think we are low life's and there sh*t don't stink. Jeez, I have no use for their kind and bet they all claim...
That's why I don't visit here much anymore. Y'all build yours the way you think is best and I will do the same. May the best man win! 78...
Low compression and or plugged exhaust system.
Camshaft and gear ratio plus low compression may be contributors to your problem.
They are the right one's. But with 4:11 ratio, tire spin will increase so a mini spool or some other locker set up will help. Not real good to use...
My 2000 150 has towed race cars as well as a dailey driver, 140000 and no problems with it. Friend has a lightning with close to 400000 and did...
Have you put the weight of the car on the ground? Sometimes it will allow the shaft to push foward. If it still has some front yoke showing about...
Got any pic's?
Agreed stagger them.
Had one done yrs ago on a 75 Mav without pulling the glass. Fellow used to work on all the Hollywood movie cars and many celebraties personal...
Most trays are made to fit on main girdle. For the amount of work and precision measurements required, I would buy one from a "reputable" vendor....
Personally with your combo I would use performer rpm heads. Deck the block to 0 and use a good flat top piston for street performance. A good hyd....
It has a cam specialties bump stick, solid roller 705 lift. H beam rods and Probe domed pistons, 15to1 compression with Vic Jr. heads. Parker...
