Separate names with a comma.
My 70 Maverick still has the original trunk mat as well and it is plaid vinyl. By the way, my car was built on July 3, 1969. So from this I can...
Pitman arm?!! Hhmm, that is weird! First off, I haven't been aware of any pitman arm problems with these cars since the arm itself doesn't...
Here are the links for Pro-motorsports engineering. They say their variable rate springs are made by Eibach. It is likely things have changed...
Does anyone know where I can get a new plastic retainer for a V8 accelerator cable? I am refering to the circular blue plastic retainer that...
Hey man, thanks for the info. Regarding your rear sway bar, where did you buy it? As for the coil springs: Stock springs were in the 250-300...
I am going to purchase a sway bar kit from pst. They list a 7/8 front and 3/4 rear for the Maverick but up to a 1 1/8 front and 7/8 rear for...
I tried to post pics over the weekend. Unfortunately, my pics were too large. I will try to shrink the size and re-post them. When I post pics,...
My 70 Maverick rad support along with my pops 73 Grabber rad support are both welded. The stamping is slightly different but both are deffinitely...
Scrapper60 is right, 71-73 Mustang parts are an exact swap. The only difference is I think some early 70 models(like mine) had the 4 bolt upper...
I would either use your stock shackles and use new poly bushings or get the whole shackle kit from www.p-s-t.com.
I would be interested in a set if the price is right. By the way, I too am a Mech. Engineering major. I am 1 semester away from transfering TO...
Are you currently attending Cal Poly? If so, are you a Mech. Eng. major?
I actually used their heavy duty leaf springs on my 70 when I did the v8 swap. The are actually very good springs. They are stiff enough for...
You can buy the lower spring support from many sources. In fact, one easy way to get it is to buy it from a Mustang parts supply company because...
I used the 88300 Hedman hedders on my 70 about 5 years ago. They can only be used with an automatic trans and it MUST be a floor shift! I...
I will take some pics probably tomorrow night and try to post them early Saturday.
I have a D4TE 351W block and it has extra stud bosses cast into the main webbing area. It is very much like the 351C main area(all 351C were cast...
Thanks man. lol :) I didn't even realize I did that until you posted. :slap: I should check what I write a bit better.
I just want to say thanks to everyone for their input. It is greatly appreciated!
It does have the "luxury" type interior so I am not sure if this means it has the LDO option. Is it possible for the 73 Grabber with LDO to have...
