Separate names with a comma.
It seems even with old tecnology they could have made a better set-up that would have maintained most of the stoping power of the front or back....
Joe Based off what I know about brakes (not a lot) I would agree with you. If you are saying at the exact time of failure I would have had some...
?? Thanks for the replys. I thought the reason for going to the two compartment/dual piston master was to prevent a complete failure. I guess I...
My son was drivining his 73 mav a few days ago and lost all brakes. Fortunately he was able to get to the side of the road. This car has manual...
The two that are not working this time are the oil pressure and the water temp. I checked the printed circut the last time I had the dash out and...
It seems I can never get all the pannel lights to work. They are all good. I believe it is the connection between the wiring harness and the...
Thank you for the diagram. Not sure why they run it through the back up light switch. It apears that if I rmove the purple -white from here It...
I changed out my front seat belts to a newer style. I did not reconect the conectors to the seat sensor and the new seat belts were not setup for...
After running out of gas with a 1/4 of a tank show on the gage. I did all the checks listed in the Manual. It appears the IVR is bad. No pulsating...
Thanks Thanks for the info. I will most likely keep it for looks but will use a better Jack for on the road repairs. Floor jack for the shop
This is the Jack that came in my 73 Mav. I have never had one that did not have a plate on the top as well as the bottom. It does not look like...
My 73 mav is missing the knob that is used to adjust the side mirror. Anyone found a good substitue?
I have a 73 Mav Grabber. It looks like someone at some time removed what I would think to be an exclusion device from the inside of the filler...
??? For those of us who are new and did not get a card Date and times? Would like to see some of these in person
72 Grabber total1582
Poor wording on my part Just the opposite. I don't want him to have a choice. Shoulder belt and lap belt one piece
My 73 grabber has the stock shoulder harness. I am getting this car ready for my son to drive next year to school. I would like to put a front...
I have a 73 Grabber 302 with A/C. The heater control valve is bad. I see a Motor Craft D4dz 18495-a. Or a Four seasons 74617 that look the same...
A cheap fix for now I sealed up mine with epoxy and installed a $2 fish tank check valve in the line. It seems to be working. I can't see paying...
My 73 appears to be original paint. White and red. I was told by the guy I bought the car from it was lacquer. Is that what the factory used in...
