Need Help!

Discussion in 'General Maverick/Comet' started by MAVNWOT, Apr 6, 2005.

  1. MAVNWOT

    MAVNWOT Member

    Joined:
    Feb 1, 2005
    Messages:
    46
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    near Salina, Kansas
    Vehicle:
    1972 Ford Maverick, 302 w/ B&M tranny, everything else is stock
    what is the stock ring and pinion, on a 1972 Ford Maverick, 302, C4, 8" rear end? i need help...please and thanks
     
    MAVNWOT, Apr 6, 2005
    #1
  2. Tim Wilmoth

    Tim Wilmoth Member

    Joined:
    Jan 7, 2003
    Messages:
    1,561
    Likes Received:
    9
    Trophy Points:
    162
    Location:
    Southside Va.
    Vehicle:
    1972 Comet gt
    Tim Wilmoth, Apr 6, 2005
    #2
  3. MAVNWOT

    MAVNWOT Member

    Joined:
    Feb 1, 2005
    Messages:
    46
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    near Salina, Kansas
    Vehicle:
    1972 Ford Maverick, 302 w/ B&M tranny, everything else is stock
    MAVNWOT, Apr 6, 2005
    #3
  4. Acornridgeman

    Acornridgeman MCCI Wisconsin State Rep Moderator Supporting Member

    Joined:
    Apr 30, 2004
    Messages:
    6,520
    Likes Received:
    977
    Trophy Points:
    426
    Location:
    Wisconsin
    Vehicle:
    70 Maverick Grabber, 72 Maverick Grabber Restomod
    Probably a 2.79:1 ratio - look at your door tag and look for a 3 by the axle codes. If it is a 6 it is 3.00:1

    But to be on the safe side, as it may have been swapped out at some point in the cars life, look for a tag on one of the bolts that holds the center chunk in.
     
    Acornridgeman, Apr 6, 2005
    #4

Share This Page