Hi, I was wondering if anyone knows for sure if any of these parts are correct for a 1972 V8 3spd manual Grabber... Reverse Lockout Rod: http://www.ebay.com/itm/321064321265?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649 Does anyone have the correct part # for this piece for my car? Frame Side Z-Bar Mount: http://www.ebay.com/itm/NOS-FORD-MA...nRmHttDJ%2B0rO5866ntI%3D&orig_cvip=true&rt=nc Does anyone have the dimensions of the correct one such as overall length, the measurements between the 2 mounting holes, Bushing mount/stud length and diameter, etc. Engine Side Z-Bar Mount: http://www.ebay.com/itm/NOS-FORD-MA...nRmHttDJ%2B0rO5866ntI%3D&orig_cvip=true&rt=nc I thought they had a ball end with a 2 piece bushing...did they use this style also on different years? Told this ebay item has a 1" diameter bushing which fits my correct 2 piece v8 z-bar. Any help would be greatly appreciated!
Hi, thanks for the reply. I believe the 200 6 cyl. use a smaller bushing. My 200 zbar has a 3/4" frame and block side bushing size where as my v8 zbar has a 1" bushing size. The ebay listing for the block side mount has a 1" bushing. The ebay listing for the frame side mount has the larger diameter stud which also takes the 1" bushing as compared to my 200 6 cyl. I have both these same exact parts that were listed on ebay that I've pulled out of a box of parts I've had for years from the many cars I've parted out over the years and I'm trying to match up a set for a car I'm restoring. I don't have a lock out rod so I'm trying to find the correct one and I'm inclined to believe the one in the ebay listing is a 6 cylinder like you said so that's why I was hoping to find a factory part number to go by.
Also looking for information as to what is missing on this transmission. See finger on attached pictures. The transmission is a 1972 302 Maverick 3 speed toploader, RAN CA1, dated Feb 25 1972.
Looks like the lock rod for the seatbelt switch http://1bad6t.com/Maverick/repair/clutch_transmission_01.html
I just started this thread http://mmb.maverick.to/showthread.php?t=91919 Do you have pics of the rods I'm asking about or could you measure the length of them for me?
