Your right...I didnt even look at the date I just read the posts....DUH. Deleting my post Robert
this is a comet GT black, buckets ,6-cyl, 3-speed floor shift with a ford 3 spoke steering wheel, has been in the woods for some time has several...
this has to be the longest time between a post and reply I have gotten.....I figured I would have a few raggin posts. wish I could swing going...
Forgot to mention it is a construction party:p:rofl2: As you can see from the picture I have most of the material to build the shell of the...
If you have a harbor freight near you, you can pick up one cheap. I think mine was less that 20 bucks. most of the holes you will need to punch...
Well it is time to make the big discision...how tall to make the walls. I have been tring to calculate up the costs vs. the advantage and I think...
use an inside fitting flange. did mine with 3" fitting and put a small bowl and some foam around the pipe to center the bowl. then you find the...
Well we will be pouring concrete in the morning, should be about 27 yards of it. Got the pipes ready to be hidden under the slab so I can put the...
took a look at it today on the way up to the VW show. It is a 74 with a small bumper conversion interior is shot, the buckets dont look original...
just got back from the NSRA show...went in the gate and in front of me was a 67 mustang convertible, futher down between the swap meet sheds sits...
big screwdriver or goto sears and get a seal puller...I have one of theirs and I use it to get the seals out of mine...works good. Robert
well we made progress this week. we should have concrete poured on monday or tuesday. Robert
That isnt too far from me I may be headed up there to the VW show this weekend. Going to try to go to the NSRA in knoxville to look over the swap...
I have the pertonix module and coil on the grabber I got last fall. the the pertronix II coil I was told at Performance Products where I got it...
Your biggest increase for wire will be from the alt. to the battery and to any heavy amps you put in the trunk. the rest of the factory wiring...
Local pull-a-part, got mine off of a 3.8 lincoln continental. Tip: take a set of torx bits with you to take the brushes out so you can see...
not many comments.....usually get more than one. Robert
Just take the back seat out and reach through with a long pair of needle nose pliers and unhook the spring and bar then use a long...
Here is the pictures he emailed me...at least the links. Robert...
try 14 months...at least that is what I have heard. Robert
Separate names with a comma.
