On Sunday morning of the Legends race we only had one time run. On that run I sheared the roll pin of on the distributor gear just after launching...
The only thing I need to do is wash the car and load it on the trailer. Hope to see some fellow board members at MIR this weekend.[ATTACH]
I do plan on being at the legends race at MIR in September. As for fitting a 32" tire in the rear wheel opening I did have to fit the tire to the...
Here is a web link to instructions that helped me quite a bit on doing my car. http://autoweldchassis.com/Instruct.ivnu
Here is a picture of the car when I bent the wheelie bars and the rear valance. I have sense toned down the wheelie tendencies. [ATTACH]
Here are pictures of the finished car. Motor is a 532 CID big block. best time is a 9.02 at 147 mph.[ATTACH] [ATTACH] [ATTACH]
I have just finished a back-half 4 link Maverick this spring. I used the Competition Engineering jig welded 4 link rear clip and the Jegs 10 point...
I have been working on a 74 Maverick that is going to be a dedicated drag race car. I am at the point of wiring the car, I have removed all of the...
I am in the process of backhalfing my 74 Maverick. The rear frame rails are 28" outside to outside, the 9" housing is 43" wheel flange to wheel...
I am sorry it has taken so long to reply to the motor reassembly subject. The condition of the engine when it arrived at my shop was the short...
If you don't want to tub the car for bigger tires, and am looking for a street driver with superior handling, I would use the subframe connectors...
I looked through Ebay and noticed the kits in the $200 to $400 range were kits for just the brackets, heim joints and tubes. To do a four link and...
Let me know if this is what you need.
Here is a picture I have but it dosent show the conector verry well. I’ll take another picture tonight and post it.
Thanks That's the direction I was leaning towards. Any other suggestions?
The pictures below illustrate what the problem is. I think that the FMS 90* adapter will not solve the problem because the owner wants to use the...
Having broken up a couple 8” rears in my time, if you have any amount of HP I recommend at least swapping out the old 28 spline axles with a fresh...
Oh yea I will do almost anything to keep from welding overhead.
Now that I have the picture posting figured out here are some pictures of the Mavericks I have worked on.
Thanks for the warm welcome. This is my first attempt at posting a picture. This was from MIR Sunday before last. I hope it works.
Separate names with a comma.
