Re: Driveshaft
Re: Driveshaft -- Chris	Post Reply	Top of thread	Maverick Message Board

Posted by: rickyracer 02/12/2002, 19:48:01

actually just find a drive shaft from any Ford/Merc and have it cut down. Get a trans yoke that fits in the output shaft and get your rear u-joint size and have it cut and balanced. You can even use the alum ones that are out there if the shop can work alum.

Post Reply | Alert

Original message Top of thread Return to the MMB

Replies to this message

I concur with Mr. Racer --- Rick ( 02/12/2002, 22:37:49 ) ( 394 bytes ) link You might consider this inexpensive drivehshafts: --- Charlie Ping ( 02/13/2002, 10:46:30 ) ( 360 bytes ) +1 v8 driveshaft --- Jeremy ( 02/13/2002, 18:01:30 ) ( 307 bytes )