I concur with Mr. Racer | ![]() | ||
Re: Re: Driveshaft -- rickyracer | Post Reply | Top of thread | Maverick Message Board |
Posted by: Rick 02/12/2002, 22:37:49 |
Either way would be fine I would think (Steel/Al). I'm actually cutting (and re-welding) a 90 Mustang after-market aluminum drive-shaft to put in my '70. The aluminum will actually free up a few horses but may not be worth the expense for your ap. The link should give you a good start (if no one has an original to offer - even then, I'd have it checked for balance). Good luck, Rick Related link: http://www.driveshaftshop.com/VintageDriveshafts.ivnu |
Post Reply | Alert | Original message Top of thread Return to the MMB |