Hell, what's wrong with cable? I've got about 40,000 miles on my mustang steve cable conversion. Not had a single problem with it.
I put a header on my car when I had a stock 250 in it. The only thing I gained was a little gas mileage on the hwy.. The car didn't feel any...
I have never seen offset upper control arms like that. Mine are symmetrical. As for the spindle, it's impossible to have them on the wrong sides,...
It's chain of ownership, not command. What that means is that the current owner/seller is not the last legally registered owner of the vehicle, so...
If you have a Pertronix, you don't need any of the duraspark stuff. Just run a switched 12v wire to the coil and hook the pertronix up.
The first connector should be going to the Duraspark ignition module. It connects the module to the reluctor in the distributor. Not sure on the...
My '69.5 had an 8 track in it. I actually went through the trouble to put a new belt in it and clean the head, lube the mechanism inside it. My...
Just go to a junkyard and grab the newest looking 3G you can find off any 90's Taurus/Sable/Mustang. Take a tape measure and make sure you get one...
Drove it to work, like everyday. Came out of work to find my right rear tire flat, sheet rock screw stuck in it. Put a plug in it, aired it up,...
I'm with Frank on this... I've never marked a drive shaft prior to removing it, and never had any vibration issues as a result of that. Ford most...
:Welcome: You shouldn't have any trouble keeping up with traffic with the 200. They're no power house, but they'll run with traffic just fine....
Another option may be the 5 cylinder OM617 Mercedes diesel. They came in a bunch of 70's and 80's Mercedes, very common and cheap, at least around...
My only concern would be the weight of the engine. I've seen those swapped into all sorts of stuff, even saw a late 70's El Camino with one in it...
The location of the holes for headlight adjustment
I have one on an '89 5.0 H.O... that's in my '72 Chevy pickup... it worked great for a couple of years, put about 15k on it, but recently the...
Same old, same old.. Clutch started slipping last weekend if I get on it too hard while taking off from a light. Also noticed the car is leaving a...
Discovered rear main seal leak on the road warrior. Turned my 200,000 miles of road grime under the car into wet black goo..
Well, the engine and trans rolled off the assembly line in an '80 Mercury Capri that was built at Dearborn. Does raise an interesting...
My '72 beater is a K as far as the body shell. Has a W rearend, F motor and trans, X front spindles and suspension. and some other non Maverick,...
Here is what I did to gain some clearance: http://mmb.maverick.to/showthread.php?t=47628&highlight=taurus+fan As you can see, the fan motor is...
Separate names with a comma.
