so today one of the guys at the autocross that races a 69 mustang showed me his newest mod. its a bump steer correction kit that also moves the...
learning to read the cones was the first hard thing to figure out. its like learning a new language. we do a course walk before we run, so that...
today was great. i took first! out of 2 cars. the other car was a falcon that has been really fast. i used to be around 7 seconds slower. heres...
hey chip, ive been thinking about getting a hydraulic crimper. ive been having increasing need for one at the shop. the cost range on these are...
ive done several borgenson steering box installs on mustangs. they are great in being able to provide a modern steering feel. the 3 things im not...
so i have 11 videos from yesterday. i didnt put them all up because i think they all start looking the same after watching them. i can load them...
had an autocross practice today. it was a blast. heres some of the runs. [MEDIA] so at the last practice i wasted my gears in the diff. it had...
i looked at those. the problem i have is this is a truck housing and its tubes od is 3.125. i didnt check the id but its going to bigger than than...
I'm not sure. I'll check on Monday and see if it has a brand marking on it. It's a good chance it's a motive gear set by I'm not sure.
i have sealed axle bearings, so their is no need to let oil get out there.
so i finally got a chance last night to get into my diff to see why it was screaming after the last autocross. this is what i found [IMG] what...
we installed the motor in navyfc117's other car this week and it started right up. [MEDIA] so to summarize, the timing chain had jumped some...
usually the application guides have the rear u joint wrong. its an odd ball u joint. it uses a bigger diameter cap on the part that goes into the...
ive put shims in mine. if you want performance handling in these car you cant put too much caster in them. i would do the control arm shaft twist...
I use a 3/8" bokt that is flat head style. I will drill the hole then use a tapered countersink to get the bolt head flush with the face of the...
so we have the fi tech efi installed and running. now i can say its great. the install was the easiest efi ive ever installed. just 4 wires....
im not sure what the logic of ford was on what got staggered shocks and didnt, but i had the same issue with lowering blocks. i put spacers the...
the coil will get full battery voltage while cranking then will be switched to the feed from the resistor wire when the key is in the run...
i dont know what the stock height was. it has coil overs on the front that allow me to adjust the front height and the rear is 4 leaf espo springs...
i have 275-45-17s. my fender lips are rolled and pushed out. i took a 2x4 and put it on the inside of the fender lip. then took a scissor jack...
Separate names with a comma.
