Drove it to a car show out in Dallas. Ran into Dan Hines Didn't see the owner of the green one
Yes, sounds like you are correct. Did he give you a printout of the alignment?
Depends. The appraiser that looked at mine took overall condition and modifications into account. I don't think there is a Kelly blue book number...
You'll need to find a good alignment shop that is familiar with older cars and modifications that affect the factory settings to get the best...
Classic car adjusters are familiar with our cars. If they come out and try to total it, get your own estimate for repairs and resubmit it. Don't...
What is your caster? I'm unsure about what it takes to inform the system of center but if you can find an answer for how it's determined, you can...
I used Global West and they locked down tight when I torqued them. Is your cross member damaged or rusted out in that area?
Looks repairable to me.
The only issue I had was that fluid displaced with brake pad wear would empty the reservoir before the front pads needed replacement. Just...
Yeah I think the steering is the worst part.
I have 3.50 now which is nice for red light to red light and mountain driving but for the highway I miss my 3.00's. I use a 94 Cobra T5 with a...
That sounds fair. If their insurance is like ours, the deductible is around 10K for the company. You both may have made out ok.
Sounds like a cool idea. I can say that I have been 135 mph in mine for just a minute and had the same experience as Bryant. I have no added...
245/50r16 on a 16X7, not 100% sure on the backspacing, but I believe it's 4". rubbed a little on the valance panel but after I adjusted the strut...
Nice!
All of the secondary ignition components are Ford Motorcraft. I have scraped the contacts in the cap once but it wasn't causing an issue. I am...
Being budget minded, I would be leaning towards the Duraspark distributor with Motorcraft wires. I am using the same wires, cap and rotor I put on...
Nicely done!
I always remove the perch to gain a little clearance and if it's doable, the entire upper control arm. I'll remove the nuts from the upper...
My metal blower wheel never came loose in the many years I had it so I wouldn't worry about that so much, but you can loctite the set screw if...
Separate names with a comma.
