When you raise the car up, put a short 2x4 between the upper control arm and the frame so the suspension won't completely extend. For the...
The default for the factory AC system is defrost. If you take the vacuum supply away or there is a leak present, it will divert air to the...
You might need a manual if you aren't at all familiar with these cars as a lot of the information you will receive assumes at least a very basic...
While it's cold outside, bypass the heater control valve altogether. Just run both hoses directly to the heater core from the engine and not...
The relay coil will work just fine with the resistor wire. I'm right there with you on the too damn cold thing...
Here is mine. I use them as sport lamps with clear bulbs and the turn signals under the bumper.
I love the simplicity of a 6! Nice work!:thumbsup:
Fuse links are covered with a rubber type coating that doesn't burn when the link fails for safety. Over time the rubber will break down...
I had an 85 EXP that I did this to, especially important on the cooling fan circuits. I cut out all of the Maverick ones and the ones in the donor...
Welcome, from GA!:tiphat:
Good general info here: http://www.whiteproducts.com/fusible-faqs.shtml
The square piece is designed to put the hole in different locations so you can adjust camber but you do have to remove the bolt instead of just...
The control arm inner bushing is knurled and may be difficult to move. You do not have to remove the strut rod to move it. The arms are easier to...
I would bet it doesn't generate much heat at all since they used a wire taped up in a harness.
I have used radio shack resistors in place of the resistor wire in several instances with no issues. 8-10 ohm should do the trick if the...
My understanding is that it prevents "sloshing" of the needle. Modern cars use circuitry for this effect. I installed VDO gauges and the fuel...
It WILL leak into the ECU, no doubt about it. That flat spot under the case is the catch for the evaporator. There is space above the AC box as...
Took a stock speedo apart to see about converting it to an electric drive, cleaned up the fuel gauge and idiot light plate
I'm using these brakes currently on my 8". I had to file the holes slightly as well but they line up and are centered. I did this conversion...
Separate names with a comma.
