If your setup has adjustable fan control, possibly fan is running more than necessary hampering your heat output!
Got started moving some wires around to get the starter installed; had to get little creative with so many wires on fender mounted solenoid/relay...
The way you have outlined is what Powermaster specifies. Best follow mfg's instructions since they have done the research. Thanks!
That will be easy way to do it. You’re saying, connect pm starter to S terminal? Also, reconnect or have OE fender wire connection and pm wires...
Preparing to install PMGR starter, Power Master instructions specify, not connecting jumper wire between main power line to small ign. switch wire...
How you figure that happened? Must have been in place to lift the car!
What’s the plan for it?
Were you able to get enough pos. caster without adding shims to UCA’s to get satisfactory tracking? I had to add shims after installing Borg. PS...
How many cooling fan units are you running?
Got a good click from old & new solenoids. Had car 14 years, don’t know how many years starter was in service before I got it, so good bet to...
Thanks for diagrams and information. I used remote starter button on s terminal to battery, not even a grunt. I used it on old solenoid and new...
I think your correct on NSS switch would not have a bearing on starter engaging going to starter. Actually going to firewall side of solenoid is...
Looking for information on possible way to test starter on vehicle? Tried going from battery to starter side of solenoid, nothing. I know I need...
Don’t know if these were widely available 11 years ago; knowing this now , I would go this route.
Did this update May 2012, probably little overkill as far as wiring goes but have served me well w/o any problems!
Barry has detailed thread on his CPP installation— required some modifications.
I’m at a point in time, don’t do enough night driving to consider much in way of headlight upgrades. I did upgrade few years ago to some Sylvania...
My car has 2.79 gears @ 70mph about 3k IIRC. I’ve made several road trips in the 13 years I’ve owned it. Shortly after I got it, had rear end...
After all the things you have stated done to the engine; I believe there is some kind of restriction inside the block. Since head-gaskets were on...
I would check lower rad hose for possibility of it collapsing; I replaced my lower hose, didn't come w/ spring -- put spring in from old hose. I...
Separate names with a comma.
