CNG conversions are available to fit just about any carbureted application. They just may not be legal in your state. The real issue you will...
Why would you want to? How about incredible low end torque, smooth idle, decent fuel economy with the right trans, etc. The 300 Ford 6 is a great...
"Sure is nice having a new and tight tranny!!!" :rofl2::rl::rofl2: Out here in CA, you have to be careful with statements like that!! Remember,...
Really, the decision of which type of suspension to use depends on the intended use. Are you drag racing or road racing? I assume drag with a 552...
I dropped off the front and rear bumper that needed re-chroming which included all the brackets, bolts, etc. I knew these to be completely...
:rofl2::rofl2::rofl2::rofl2::thumbs2: Nice call from the young guy. :D
I am running the P235/55ZR17 tires that came on the rims. I suspect the difference may be that I am running the Fatman Fabrications dropped...
Okay, I understand what you are saying Bryant, but there are too many unknowns with his combination. If he had a stock short block, I would say he...
That is really scary. Think of how long the lever arm is in that picture. I would not trust that at all. Consider the forces placed on the rear...
I have the same `05 takeoff rims and tires on my beater car. I needed 2" spacers for the front and 1.75 inch for the rear. No rubbing in the back....
Yes, if you have a manual center link, pitman arm and idler arm from the same year as your car, there is no problem swapping these parts in. The...
Reading through those posts, there are a couple of things that come to mind. 1. Remember to lube the bolts when you install them. While rust is...
Ed, it is really important to know what type of racing you are planning to do when you build the cage. Each sanctioning body has their own...
I have installed them in Mustangs and a Falcon. Just follow the directions, measure everything, then do it again. After that double check your...
I did the Shelby drop on a '72 that did not have the extra bracing that is shown in your picture. I was able to use the 90 degree zerks in that...
They sent you 65-66 uppers. You need the 67-70 upper control arms which are the same as the Maverick. The 65-66 arms are shorter in length and...
I have done both of these things. 1. Shelby drop of 1". When I did this, I used a template for a 67 - 70 Mustang (available from most Mustang...
True, there are no 2" dropped spindles. However, there is a Granada 2.5" dropped spindle from Fatman Fabrications. Do a search and you will find...
15 x 7 with 3.5" (neutral) offset. I have a set of 2007 Mustang GT takeoffs that are 17 x 8 that I will be putting on that car. That will take...
Okay, the real skinny is that they work fine as long as you know what to expect. There is a good set of instructions on the fatman web site for...
Separate names with a comma.
