Were they stock rods? Very common place to break, stock rods will not hold up to nos and high rpm's. Also if there is to much crank lateral...
You will need a balancer puller to get it off. Can be rented at some parts store's. The seal in the cover should be put in with a seal driver but...
Thanks guys, turns out the storm had no rotation but 70mph straight line winds. Race is rescheduled for this coming Sunday. In all my thoughts of...
After putting a few gallons of diesel fuel in the Ford tow rig(100 bucks) headed for the strip at Centerville, Ar. It was another 1000 dollar...
This is alway's a good meet, and it is on top of a great mountain getaway. Also if you go down the west side of the mtn, 15mi, you will reach the...
Had the same problem many years ago on our race mav, using a 302 and similiar spec's as yours. Was using a stock valve body and cheap brand type F...
Have only been able to access the MMB a couple times in the past month. Everything else in my favorites, etc. works fine. Have been getting the...
Check trans fluid level and also make sure converter is not rubbing the bell etc. Possable tranny rebuild is eminent if fluid level is ok. Sounds...
And the story continue's Arrived at the track early Sunday to beat the crowd, had unloaded the Mav on Sat and fueled it and such for Todd. Time...
With the tornado’s all around us last week, did not figure the 1000 dollar Pro/No/E race, would not stand a chance of being run. But just like...
Never saw that conversion myself but I run a power glide behind my 347. Is a fairly easy conversion but a bit exspensive. Have to cut the PG bell...
May want to just put in a new wheel cylinder. Saves time and frustration and cost is fairly cheap.
Ditto from me too. How is the wife and new baby doing?
She is a real winner in all respects. Never gave up and stay's focused on her job. Let's not forget Ashley Force too, and all the other ladies in...
Just remove the wheel and measure across the diameter of the axle flange sticking out of the drum. That is the same as the drum.
I don't think the propane torch will work, not enough heat. I have alway's used a acetyline torch and get the bolt, nut, pipe plug, etc. cherry...
It is a bit tricky to do it with the trans in the car, unless you have done them before. I would pull the two together using the plate on the...
Hope it is just a gasket problem, Jerry. Had a similiar deal with intake gasket's that were not sealing at the water ports.
How new is the timing chain?
Drop pan and clean or put in new filter. Look for lot's of gray gook or speckles of brass etc. If all look's fine Install new gasket and some new...
Separate names with a comma.
