I appreciate the site but im not sure its even the drive shaft just and odd groaning noise that resonates throught the car. i know its not motor...
i might have broken it but i havent messed with the drive line for over 6 months and i have not replaced that part. when i got my gears and posi...
I was wondering how to tell if you have a bad driveshaft? A week ago I shifted out of 1st too 2ed and it slamed hard. The trans is a c4 full race...
just finnished it up and it working well. Now i don't suppose you know how to open and rebuild an msd box? (j/k) Thank you again for your help...
that is kind of what im thinking happened. I have been reading a wiki site about relays but not sure how to hook one up. thank you for confirming...
I just bought a flex light electrical fan and was hooking up the wires. so i ran the postive wire to the only 12v wire that i know of under the...
How far away from the fire wall dose the motor sit? My fan is about 2 inches from the radiator.
I'm 90% that the shorter end goes toward the front of the car. The gauge would be your transmission would not mount if you had it backwards.
yeah they fit fine. had them for a while. i was asking because i pulled the motor and for some reason the headers and about 1.5 inches from the...
ok long tab forward. thank you.
http://www.mustangdepot.com/OnLineCatalog/Engine/motor_mounts.htm
no i do not have shround. Lnow where i can get on thats not $200
the one that came with the new radiator and i have two new ones from summit.
So far i still have the the car running around 200 even with new hose t-stat and coolant, and now radiator. What is the normal operating temp...
On the 302 motor mount dose the long side of the steel part go twards the front of the block or the rear?
What radiator woould you suggest?
My car sits at about 210 on a 78 deg day with a 160 t-stat. It sat at the same spot with a 195 t-stat. WHat is the temp supposed to be? I have a...
yeah its turing out that way just wish the machine shop would have mentioned that before. thank you. It feels good to get the same answer.
i had my 302 heads machined for studs for roller rockers and they instaled a push rod guide plate but the push rods are rubbing on them and...
about a grand
Separate names with a comma.
