Im running 3.55's with a T-5 on mine and I noticed that my MPG slightly boosted after changing to 3.55's from 2.79s. This is what was probably...
Heater box is still in there with the vents.Ill try to remove it tomorrow. Check your inbox.
I am going to part it out and hopefully try to find a decent shell to thrown in the 250 and C4 in it. If that doesn't go as planned then I will...
Its a 73 four door No A/C Power Steering Sport Mirrors 5-Lug Drum brakes all around 2.79 Gears
So I've came to the conclusion that I am going to part out my 4 door Mav. It belonged to my father who passed away in 2003. It's been sitting...
Next I realized that my tail panel was not straight.I noticed when I was taking off the tail lights that the passenger side is pushed in a bit and...
I just found a set on ebay last week and they were NOS. Try ebay, usually everyone sells them in singles I was lucky to come across a pair. What...
The spoiler is a little too much to the left side. What do you guys think? Does it need to line up perfectly with the trunk line? If so then I...
Once removing the spoiler off the trunk I noticed that the trunk lid had a lot of low spots and dings. It was going to take up a lot of my time...
After inspecting my spoiler I determined that it was damaged so I removed it and sure enough you could tell that it was cracked into two pieces...
The previous owner tried to put an aftermarket shifter and cut into the transmission tunnel. It didn't fit so they went back with the original...
Makes sense the casting code on the engine block said its a 69 302
I also took a picture of the casting code on the heads. Does anyone know if they are stock? It read 9M29 with a B above it. The other side has a...
They were Fel Pro gaskets with the steel grommets. The bolts heads required an allen wrench so I tightened them up hand tight.Ive been driving...
It was a hydraulic setup. Bryant on this thread was the one who did the swap for me, he can give you all the info you need. I believe there's a...
Thanks for the tip :thumbsup:
Ok thanks Craig
Works for me :2thumbs: Any preferred sequence on the tightening?
Thanks Bry everything is going good so far. I'm loving the new gears. My teacher drove my car last week and he said that the T-5 and the gears...
Im replacing the valve cover gaskets and was wondering if anyone knew the bolt tightening sequence as well as the torque spec. Thanks
Separate names with a comma.
