I thought it read 4000$ I almost had a heart attack.. 400$ sounds like a deal.
Drove it around a bit. Waiting for the stuff to come to finish cutting and buffing the paint....thought about new seats....window tint...getting...
If I had 5k....which I did not when i built my motor... I would take a mustang 5.0L block, rebuild with some forged 9:1 pistons, good hardware...
There is a nice green comet in albany/el cerrito area I drive by almost everyday....I am waiting for a sign to pop up in the window.
is that the one that is on CL with the videos and all that? If that car is worth 5k then my non grabber is worth 10k... If not then...
Thanks for all the tips btw guys, I do not mean to sound like I am dead set on the huge money local shop rebuild, but I keep hitting a brick wall...
I have looked into it considerably the 600$ figure was to shorten the housing and axles, cut off all the crap, weld on new perches. I would...
Well now is the time...I went to three junkyards, two pick n pulls, called everywhere in the area... I did not find a single explorer 8.8 disc...
Sorry but 4.62's and spool would rack me into a wall in no time. I am trying to get ahold of a lock-right powertrax locker, but apparently the...
The 8.8's would be easier to install by just welding on perches than trying to rebuild the 8" or narrow a 9" to fit. It looks like some 8.8's are...
I did some calculations and it seems that 4.11 with my 25" tires will be at like 3200 rpm or more. Does this sound about right with the C4 1:1?
I am willing to buy a new converter and go manual valve body (in the plans already) I have a C4 I am using a trick flow stage 1 with 1.7rr's to...
I think possibly the shop that rebuilt my exploder rear end had used a cheap rebuild kit or a botched job, also the vehicle was drive rather...
MAN this stuff is expensive....tried 2 more shops before the end of the day looks like 1400$ for a tru trac ring and pinion and bearings seals...
oh darn^ My 2.80 gears are GREAT at part throttle putt putt.... WOT there is alot to be desired. Even if I got a high stall converter, it would...
That is acceptable rpm for me
75$ labor.....Id give you 150$! haha. How far are ya?
I do not want a clutch type limited slip I have had issues in the past with my 02 explorer and 8.8" killing clutches three times in a year....
Thanks ^ that is the type of input I am looking for.... A local shop would want approximately 1350$ to do the gears and a detroit trutrac, in...
Thanks for the tip, I do have rather small tires right now but going 65-70 I was doing about 2300rpm. Which is good, but I do not get out of...
Separate names with a comma.
