I had never heard of tap-away, it was sure easy to find. Tap-Away website
A Mark 5 rear end is wider, also a Mark 5 is a coil spring car so the mounts are different.
Not to choose sides but VDO makes both a 100 and 200 amp gauges, so you are not restricted to a 60 amp alternator. $25 from Summit.
The reason I didn't buy Hookers is because I don't like the drop bracket for the power steering and most people have a problem with the pitman arm...
Rebuilding stock heads for more performance can be very costly. I needed new heads for my boat. I thought about purchasing new bare castings $850,...
I have a set of trick flow twisted wedge. I have tried some shortie headers and they didnt fit, not because of the spark plug (that was ok) but...
I have run a RPM air gap on a 350 chevy. I doubt you would loose any/much low end with a RPM airgap, its not that much of high rpm manifold....
I would not buy a Performer manifold, in my opiniom they are a MPG manifold not a performance manifold. Not really any better than the factory...
You are right about the paint on headers, its just there for shipping so they dont rust. I have used VHT silver paint on headers. They were for a...
Very light looking brakes....Drag race only?
My Comet has a 1 piece vinyl roof, no seams.
I am in the same boat with my 75 Comet, the belt for the PS also drives the water pump. I might use a meziere electric water pump.
I just measured new superior replacement axles .600, the correct studs should be .615 to .625. Moroso MSR-8010 is the correct stud. Summmit $19.95
I have my manual for my 75 Comet 302, it states 2000lbs max with a 200lb tongue weight
I know its sad but I just paid $250 for the spoiler with the trunk lid. On the bright side are cars are becoming popular and the value is...
I think this company makes the scoops for auto crafters, I ordered one about a week ago but I havent recieved it yet. I got the scoop for the...
I used to drive a spool on the street, a 1970 Challanger 340. It was alot of fun, but there were several times I spun out for almost no reason....
I helped a friend replace the flor pans in his 74 Bronco neither of us are good welders but it came out just fine. We used a Arc welder, nothing...
Its way too wide and it is from a Mark 4 or 5, coil spring car.
In California there is a "Release of liability" form, send it in to the DMV and the previous owner is free and clear. It is attached to your pink...
Separate names with a comma.
