Posted by: Ken Merring
02/23/2002, 02:49:05
|
ok i have what i belive is to be a problome. i was under the hood today and i found that when i was to rev the engine up my bottom pully (crank) was moveing outward twards the radiator. it was only about a 1/16 to 1/4 inch movement but from what i know this shouldnt happen. the motor was just rebuilt with clevlite77 berings .10 over and trw flat top pistons .30 over using a standerd crank. the motor dosent shake and it dosnt lack any profmance. what would cause this? it only has about 800 miles on it?
............................
Was the bolt to hold the pulley fast to the crank put back on?
Or is the crank moving that much? If it is the crank moving that much, you got a major problem with the (thrust) main bearing installation.
|
